VOLUME 19 (Supplement)

SciEnggJ%202026%20Special%20Issue%20265 280 Bautista%20et%20al

SciEnggJ 19 (Supplement) 509-514
available online: 19 November 2026
DOI: https://doi.org/10.54645/202619SupHRY-45

*Corresponding author
Email Address: peterclydelamadrid@gmail.com
Date received: 11 June 2026
Dates revised: 19 August 2026; 19 September 2026;
28 September 2026; 29 September 2026
Date accepted: 30 September 2026

ARTICLE

Small-scale thermal distillation reactor for producing distillate oil from waste lubricant oil

Peter Clyde B. Lamadrid*1 and Francis Dave C. Siacor2

1Graduate School, School of Engineering, University of San Carlos, Talamban, Cebu City, 6000 Philippines

2Chemical Engineering Department, School of Engineering, University of San Carlos, Talamban, Cebu City, 6000 Philippines

KEYWORDS: Distillate, Physicochemical, Residue, Reactor, Waste lubricant oil

Waste lubricant oil is produced when petroleum-based or synthetic lubricants degrade and become contaminated during engine operation. Because its composition is complex and it contains impurities, it requires treatment before disposal to limit environmental pollution. This study investigated the recovery of a distillate oil and a residue from waste lubricant oil by thermal distillation in a small batch reactor. The aims were to design, fabricate and test a small-scale reactor and to evaluate the mass yields and selected physicochemical properties of the distillate oil and the residue. A descriptive-developmental research design was used. The fabricated system, built from locally available materials, consisted of a cylindrical reactor with a cover and screw locks, a heat exchanger, a water reservoir with a centrifugal pump, and an LPG burner. The reactor was 25 cm in diameter and 35 cm high, with a 1.5 mm wall and an internal volume of about 17 L. In duplicate trials at five loadings (800-4000 g), the mean distillate yield ranged from 6.21% to 25.00% and the mean residue yield from 65.00% to 90.00%, with total recovery of 89.13-96.22%. The distillate had a flash point of 90 °C (ASTM D92), kinematic viscosities of 4.16 and 1.57 mm²/s at 40 and 100 °C, and a density of 831 kg/m³. Flash point, viscosity at 40 °C and density of the distillate were within the ranges specified for automotive diesel, but other fuel properties were not determined, so the suitability of the distillate as a diesel substitute remains to be shown.

© 2026 SciEnggJ
Philippine-American Academy of Science and Engineering